ITV control vessel

How to set it up

1. The receiving data position switch of all the camera control

vessels is fitted to the same number

with the transmitting data position switch of the operation board.

But, a switch is set up between 6-F's.

(A�`F on the switch means each some letters of 10's - 15.)

2. The camera number switch of the camera control vessel is set up

so that a number may not overlap.

(The number of each camera depends on this.)

3. It is turned on only at the time of the number which the camera

choice switch of the operation board was set up to with 2.

A switch is the point attention because they are

0,1,2 and ---15 from the left.It isn't used by 0.

(A camera in automatic switching was chosen by this. And,

the camera which it doesn't want to see is skipped

by turning off this switch.)

4. The automatic changeover time switch of the operation board

is set up between 1-F's.

(The timing of switching is set up by this

by the setup value X one second.)

5. The receiving data position switch of the operation board

and a camera number switch aren't used.